Friction feeder. Independently driven by servo-motor.

Adjustable electronic pile vibrator.

Lateral feed gates fully adjustable to the width of the blank.

3 adjustable front feed knives with bogies and 3 additional smaller sets.

8 feeder belts including 4 drilled belts for suction function.

Control panel with touchscreen and buttons for all operations.

Extendable rear pile support for long boxes.

Independent section that registers the blank to one side ensuring a perfect parallelism before entering the pre-folding or gluing sections.

Independently driven by servo-motor.

Possibility to register on any side of the machine.

Fast and easy setup.

Independently driven by servo-motor.

Left hand glue flap pre-folder up to 180º.

Third crease line pre-folder up to 135º.

1st and 3rd crease openers.

Independently driven by servo-motor.

Complete set of folding hooks and helixes for smooth and accurate folding of front flaps.

Adjustable hook tension.

Set of accessories for “B” lock bottom.

Fast and easy setup.

One lower (left side) gluing tank.

Optional electronic upper gluing system upon request.

Easy to remove and clean.

Independently driven by servo-motor.

Smooth and accurate folding of 2nd and 4th creases.

Outer folding belts adjustable up to 180º with variable speed controlled by two independent servo-motors, L & R side.

Three sets of upper & lower carriers with 34 mm upper, 50 mm lower and 100 mm outer belts.

Easy accessibility.

Mini-box folding device.

Independently driven by servo-motor.

Upper and lower drive mechanism for length adjustment.

Allows a perfect understack or overstack stream of boxes.

Equipped with automatic belt tension-adjusting system.

Continuous and automatic box collection mechanism that ensures a neat transfer to the Press section, guaranteeing an aligned flow.

Pneumatic squaring device for accurate closing of crash lock-bottom boxes.

Pneumatic squaring device at Trombone section.

Aluminum plates stop the box while the upper trombone belts correct any deviation on the closing. The box is released after correction.

Motorized and pneumatic squaring device on press section. Two carriers with transport belts allow a perfect flow of boxes moving to the pressing station.

Rear stack corrector, that allows to square the boxes while falling on the lower conveyor.

Independently motorized pneumatic press section.

Manual and Automatic mode (follow up).

Upper section moves back and forward through a motorized system, allowing different box length.

7.4 meters total length with 4.0 meters of effective pressure.

Pneumatic pressure regulation.

Motorized and untimed electronic back folding system with intelligent servo-motor technology.

Two independent servo motors, one for each shaft.

Versatile and easy to setup.

Independent scoring section driven by servo motors.

Located right after Side-register section, before pre-folding section.

Allows to make deeper scores if needed.